Power transformer is the hub of transmission and distribution of electric energy, is the core component of the power network, its reliable operation is not only related to the power quality of the majority of users, but also related to the safety of the whole system. The reliability of power transformers is determined by their health, not only by design, manufacturing, structural materials, but also closely related to maintenance. This paper discusses the improvement of transformer anti-short circuit ability in power system.
Overview of 1. Power Transformers
Electronic power transformer is mainly realized by power electronic technology, its basic principle is to convert the power frequency signal into high frequency signal through the power electronic circuit in the original side, that is, up frequency, and then coupled to the secondary side through the middle high frequency isolation transformer, and then restored to the power frequency signal, that is, down frequency. By adopting an appropriate control scheme to control the operation of the power electronic device, the electric energy of one frequency, voltage and waveform is converted into the electric energy of another frequency, voltage and waveform. Since the volume of the intermediate isolation transformer depends on the saturation magnetic flux density of the core material and the large allowable temperature rise of the core and winding, and the saturation magnetic flux density is inversely proportional to the operating frequency, so that its operating frequency can improve the core The utilization rate of the transformer reduces the volume and improves its overall efficiency.
2. Measures to Improve Short-circuit Resistance of Power Transformer
The safe, economical and reliable operation and output of the transformer depend on its own manufacturing quality, operating environment and maintenance quality. This chapter attempts to answer the transformer operation and maintenance process, the effective prevention of sudden transformer failure measures.
The power grid is often short-circuited due to lightning strike, relay protection misoperation or rejection, etc. The strong impact of short-circuit current may damage the transformer, so efforts should be made to improve the short-circuit tolerance of the transformer from all aspects. The statistical results of transformer short-circuit impact accidents show that about 80% are caused by manufacturing reasons, while only about 10% are caused by operation and maintenance reasons. The design and manufacturing measures have been discussed in Chapter 2, which focuses on the measures to be taken during operation and maintenance. In the process of operation and maintenance, on the one hand, short-circuit faults should be minimized to reduce the number of shocks to the transformer; on the other hand, the deformation of the transformer winding should be tested in time to prevent problems before they occur.
(I) specification design, pay attention to the axial compression process of coil manufacturing. Manufacturers in the design, in addition to consider the transformer to reduce losses, improve the level of insulation, but also take into account the mechanical strength of the transformer and the ability to resist short-circuit fault. In terms of manufacturing process, since many transformers adopt insulating pressure plates and high and low voltage coils share one pressure plate, this structure requires a high manufacturing process level. The cushion block should be densified. After the coils are processed, the single coils should be dried at constant pressure and the compressed height of the coils should be measured. After the above process treatment, each coil of the same pressure plate is adjusted to the same height, in the final assembly, the oil pressure device is used to apply the specified pressure to the coil to reach the height required by the design and process. In the general assembly, in addition to paying attention to the compression of the high-voltage coil, special attention should be paid to the control of the compression of the low-voltage coil.
(II) short circuit test of the transformer, in case of trouble. The operational reliability of large transformers depends first on their structure and manufacturing process level, followed by various tests on the equipment during operation, and timely grasp the operating conditions of the equipment. To understand the mechanical stability of the transformer, it can be improved by withstanding the short-circuit test, aiming at its weak links, so as to ensure that the structural strength of the transformer is well known when designing.