News

Jiangsu Xinxin Electric Co., Ltd.

Let's understand the composition of dry-type transformer


Release time:

2021-12-20

There are many kinds of dry-type transformer structure, winding is an important part of dry-type transformer, is the operation of the dry-type transformer circuit and voltage stability. The winding of the dry-type transformer is inside the dry-type transformer, and its structure is complicated. Let's take a look at it.

There are many kinds of dry-type transformer structure, winding is an important part of dry-type transformer, is the operation of the dry-type transformer circuit and voltage stability. The winding of the dry-type transformer is inside the dry-type transformer, and its structure is complicated. Let's take a look at it.

 

It is a cylindrical spiral whose turns are wound against each other with flat wires. Cylindrical windings can be wound into a single layer; can also be wound into a double layer. Generally always try to avoid using a single-layer cylinder, but wound into a double-layer cylinder. Because the wire is affected by elastic deformation when wound into a single layer, the coil is easy to loosen, so that the end turns are not tight enough to each other.

After winding into a double layer, the tendency to loosen is much smaller. When the current is large, each wire turn is also selected to be wound by several wires in parallel along the axial direction, but the number of parallel wires is generally not more than 4 to 5. The cylindrical winding has a large contact area with the cooling medium, so the cooling condition is better, but its mechanical strength is weak, and it is generally suitable for low-voltage windings of small-capacity dry-type transformers.

The capacity of the dry-type transformer with slightly larger low-voltage winding turns (20 to 30 turns), but the current is very large, so the cross section of the turns is very large, so many wires (6 or more) are used in parallel. In the cylindrical winding, many wires cannot be wound in parallel. Because these wires have to be wound one by one in the same layer, the pitch of the turns is too large, and the coil is very unstable and the height is not well used.

Key words:



Business License